21
MCSP40 by MacAllister
In more detail...
GB
IE
Product functions
The chain brake is a safety mechanism activated by the front guard
(2). When kickback occurs the chain stops immediately.
Fig. 21 Fig. 22
The chain brake (2) in the
disengaged position, the
product can be operated
(Fig. 21).
The chain brake (2) in the engaged
position, the saw chain is stopped as
soon as the chain brake is activated
(Fig. 22).
Chain brake test
The following functional check should be carried out before each
use. The purpose of the chain brake test is to reduce the possibility
of injury due to kickback.
Make sure the chain brake (2) is disengaged. Disengage the >
chain brake (2) by pulling it back towards the front handle (1)
(Fig. 21).
Place the product on any suitable at surface, make sure the >
saw chain (3) is not touching the surface or other objects.
Grasp the front handle (1) with your left hand. Your thumb and >
ngers should encircle the handle. Grasp the rear handle (11)
with your right hand. Your thumb and ngers should encircle the
handle (Fig. 23).
Fig. 23
Chain brake
To Next Page
Loading...
