22
MCSP40 by MacAllister
In more detail...
GB
IE
Product functions
Chain brake
Starting / Stopping
Start the product as described, press the throttle interlock (26), >
then fully squeeze in the throttle trigger (27) with your index
nger and hold in this position.
Activate the chain brake (2) whilst the engine is running by >
moving your left hand forward against the chain brake (2). The
saw chain (3) and engine should stop immediately.
Starting
Make sure the safety chain brake >
(2) is engaged (see above). The
engine will not start if the chain
brake is in the engaged position.
Ensure the saw chain (3) does not >
come into contact with anything
before starting the engine.
Set the ignition switch (24) to >
position “I” (Fig. 24).
Fig. 24
NOTE: The engine will not start if the chain brake is in the
engaged position.
WARNING! If the saw chain and engine fail to stop when
the chain brake is engaged, take the product to the
nearest authorised dealer or service centre! Do not use
the product if the chain brake is not working properly!
The chain brake should not be used for starting and
stopping the product during normal operation!
To Next Page
Loading...
