25
MCSP40 by MacAllister
In more detail...
GB
IE
Operation
General operation
To become procient attend a recognised chain saw training >
course to learn how to operate chain saws safely and effectively.
Familiarise yourself with all the controls and switches. Practise
all movements with the product switched off.
Always hold the product rmly >
with both hands. Hold the front
grip with your left hand and the
rear grip with your right hand.
Fully grip both handles at all times
during operation. Never operate
the product using only one hand.
Only use the product with a >
secure stance. Hold the product
to the right-hand side of your
body (Fig. 29).
Fig. 29
Basic operating / cutting procedure
Check the product, as well as accessories for damage before >
each use. Do not use the product if it is damaged or shows
wear.
Double check that accessories and the guide bar/saw chain are >
properly xed.
Check the fuel and chain oil level, rell if necessary. >
Always hold the product by its handles. Keep the handles dry >
and free from lubrication to ensure safe support.
Ensure that the air vents are always unobstructed and clear. >
Clean them if necessary with a soft brush. Blocked air vents may
lead to overheating and damage the product.
Switch the product off immediately if you are disturbed while >
working by other people entering the working area. Always let
the product come to complete stop before putting it down.
Do not overwork yourself. Take regular breaks to ensure you can >
concentrate on the work and have full control over the product.
To Next Page
Loading...
