MCSP40 by MacAllister
Getting started...
GB
IE
Before you start
11
Place the product on a stable, level surface. We recommend >
laying a non-ammable sheet under the product.
Mix a regular-grade unleaded petrol and a quality engine oil for >
air cooled 2 stroke engines in a suitable container (Fig. 13).
Use an anti-oxidant added quality oil expressly labelled for air- >
cooled 2 stroke engine use (JASO FC GRADE OIL or ISO EGC
GRADE).
Do not use BIA or TWC (2 stroke water-cooling type) mixed oil. >
The recommended mixing ratio for petrol:oil is 40:1. >
40:1
Fig. 13
Unscrew and remove the fuel >
tank cap (29).
Fill correctly mixed fuel/oil into the >
tank using a fuel funnel tted with
a lter to avoid debris entering
the tank. Do not overll. Leave a
minimum 5 mm of space between
the top of the fuel and the inside
edge of the tank to allow for
expansion (Fig. 14).
5 mm
Fig. 14
Avoid spilling and overlling the tanks. >
Wipe up spilled fuel with a soft cloth and ret the fuel tank cap >
(29). Use the combination spanner (32) to tighten the cap (29)
properly (Fig. 15).
WARNING! Fuel and oil are highly inammable! Fumes
will explode if lit! Ensure that there are no naked ames
around the product! Do not smoke while lling fuel and
oil!
NOTE: Never mix fuel and oil directly in the tank of the
product.
To Next Page
Loading...
