40
MCSP40 by MacAllister
In more detail...
GB
IE
Care and maintenance
Inspect the spark plug every 25 hours or prior to long-term >
storage over 30 days if the use has not been this high. Clean or
replace with a new spark plug if necessary.
Remove the air lter cover (13) and air lter (14) as described. >
Disconnect the spark plug connector (15) (Fig. 58).
Use the combination spanner (32) to loosen and remove the >
spark plug (Fig. 59).
Fig. 58 Fig. 59
Check the spark plug for damage and wear. The colour of the >
electrode should be light-brown coloured.
Remove debris from the electrode with a soft wired brush; avoid >
heavy cleaning of the electrode.
Dry the spark plug with a soft cloth if it is wet from fuel. >
Check the spark plug gap. It should be 0.5 mm (Fig. 60). >
0,5 mm
Fig. 60
Replace with a new spark plug if either the electrode or the >
insulation is damaged.
When replacing the spark plug, rst screw it in hand tight and >
then lightly tighten it with the spark plug wrench (32).
Spark plug
WARNING! Do not over-tighten the spark plug to avoid
any damage!
Attach the air lter cover (13) and secure it with the screw (12). >
To Next Page
Loading...
