24
MCSP40 by MacAllister
In more detail...
GB
IE
Product functions
Disengage the chain brake. >
Squeeze the throttle interlock and throttle trigger. The saw chain >
runs.
Push the front guard (2) to check if the chain brake works >
properly. Then disengage the chain brake.
Grip the product with both hands, left hand holding the front >
handle (1) (do not hold chain brake) and the right hand holding
the rear handle (11).
Stopping
Release the throttle trigger (27) >
and let the product run in idle for
a while.
Set the ignition switch (24) to > “O”
(off position) (Fig. 28).
24
Fig. 28
Starting / Stopping
WARNING! The product will continue to work for some
time even after the engine has been switched off! Wait
until it comes to a complete stop before you put the
product down!
To Next Page
Loading...
