53
MCSP40 by MacAllister
In more detail...
GB
IE
Technical and legal information
Getting started
Do not operate the product indoors, it produces poisonous >
exhaust fumes whilst the engine is running and may be colourless
and odourless.
Do not wrap the recoil starter rope around your hand whilst >
starting the product. This may result in injuries to your hand or
ngers.
Do keep handles dry, clean, and free from oil and grease. Greasy, >
oily handles are slippery causing loss of control.
Do not operate the product with a slack chain. A slack chain may >
jump off the guide bar and cause serious or even fatal injury.
Do not operate the product with one hand! Serious injury to the >
operator or bystanders may result from one handed operation.
Keep all parts of the body away from the saw chain when the >
chain saw is operating. Before you start the chain saw, make
sure the saw chain is not contacting anything and free from
obstructions. A moment of inattention while operating chain
saws may cause entanglement of your clothing or body with the
saw chain.
Do shut off the engine before setting the product down. >
Operation
When sawing ensure the product does not touch any foreign >
materials such as rocks, fences, nails etc. Such objects may be
ung out and could result in damage to the product or serious
personal injury or even death.
Never operate the product on a ladder or other insecure >
support.
Stop the engine if the chain jams in the cut. Do not try to pull >
the product free. Use a lever to open the cut and free the chain.
Failure to do so could result in serious injuries or death.
Do only cut with the engine at high speeds. >
Do use extreme caution when cutting small size bushes and >
saplings. Slender material may catch the saw chain and whip
toward you or put you off balance.
Do operate the product only in well ventilated areas. >
Do not operate the product with one hand! This product is >
intended for two handed use only, with your right hand on the
rear handle and your left hand on the front handle. You cannot
control reactive forces and you may lose control of the saw,
which can result in the skating or bouncing of the bar and chain
along the limb or log.
Do not operate the product if you are tired. >
To Next Page
Loading...
