MACAP LEO 55 - Installation Procedures

37
LEO 55 - LEO 55 essential
EN
The installation must be performed by
qualied technical personnel. The installa-
tion must be performed in conformity with
current safety regulation of the Country
where the product is used.
The machine must only be installed in places
where it is easy to use and access.
The support surface must be at, dry, smooth
and guarantee perfect stability.
The recommended height of the base is at
least approximately 90-100 cm from the ground
(g._4.1).
g_4.1
Do not use or install where water jets are used.
In order to ensure normal operation, the machine
must be installed in areas where the room temper
-
ature is between +5°C and +36°C and humidity
does not exceed 70%.
Ensure that there is an open area of at least 10
cm on each side and at least 30cm above the ma-
chine to allow adequate ventilation, simple co󰀨ee
relling and facilitate its use and the performance
of any maintenance operations. (g._4.2).
If the machine is wet or very
damp, wait until it is com-
pletely dry before installing
or using it.
g_4.2
MACCHINA
IN
MANUTENZIONE
VIETATO
L’ACCESSO
oltre questo limite
ATTENZIONE
ORGANI
IN MOVIMENTO
ATTENZIONE
CORRENTE
ELETTRICA
MANUTENZIONE ORDINARIA
OLIARE INGRASSARE
TUTTE LE PARTI IN MOVIMENTO
OGNI 30 GG
4 INSTALLATION
?