PRE-DELIVERY INSPECTION
Form 169007 42 Revision D
K. LUBRICATE HEADER
Refer to the illustrations for lubrication points:
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not
take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
f. Use clean High Temperature Extreme Pressure
grease.
(continued next page)
KNIFE DRIVE BEARING - DK
(BOTH SIDES)
KNIFE DRIVE SHAFT - DK
15 PUMPS MINIMUM
(BOTH SIDES)
D60
High Temperature
Extreme Pressure (EP2)
Performance With
1% Max Molybdenum
Disulphide
(NLGI Grade 2) Lithium Base.
To Next Page
Loading...
