MacDon M155 - Page 10

MAINTENANCE AND SERVICING
Page 8 of 8
g. Install L9 nuts and L9 washers, and tighten to
170 ft·lbf (230 N·m) using the tightening
sequence as shown above.
IMPORTANT
Verify nuts and washers are L9 by
checking for markings (A) shown above.
NOTE
To avoid damage to wheel rims and studs,
do NOT over-tighten wheel nuts.
h. Repeat sequence three times.
i. Lower windrower, and remove jack.
j. Re-check the torque as per Section 7.12.1.2
Drive Wheel Nut Torque.
A








/VUTTIPVMECFJOTUBMMFEESZ


187
Replaces Page 187 in M105 Op Manual
187
Replaces Page 187 in M105 Op Manual