Mackie THUMP212XT - Page 8

Thump212XT and Thump215XT 1400W Enhanced Powered Loudspeaker Series
8
Thump212XT and Thump215XT 1400W Enhanced Powered Loudspeaker Series
Daisy-Chaining Multiple ThumpXT Loudspeakers
Hookup Diagrams continued…
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
USB 1-2
USB 3-4
MUTE
MUTE MUTE MUTE
MUTEMUTE MUTE
ProFX10v3 Mixer
To next
ThumpXT
loudspeaker
input
To next
ThumpXT
loudspeaker
input
Main
Outs
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
CH1 CH2 MAIN
THRU
LINE
MIC
LINE
U U
MAX
LINE MIC
U
MAX
∞
-
∞
MAX
-
∞
GAIN VOLUMEGAIN
To next
ThumpXT
loudspeaker
input
ThumpXT loudspeakers may be daisy-chained via the “THRU” jack which outputs all inputs. Simply plug the signal source
(i.e., mixer output or microphone) into the input jack(s), and patch that loudspeaker’s mix out jack to the next loudspeaker’s
input jack, and so on, daisy-chaining multiple ThumpXT loudspeakers. See above for visual representations of daisy-chaining.
NOTE: Make sure to set the gain knob(s) correctly. In the top diagram, all input channes are set to “LINE” and in the bottom
diagram, input channel  of the first ThumpXT is set to “MIC”, but the remaining ones should be set to “LINE”. Keep in mind
that these “MIC” and “LINE” markings are for reference only and may need to be raised or lowered.