© 2018 MacroAir Technologies Toll Free: 866 668 3247 Fax: 909 890 2313 www.macroairfans.com 3
Rev. Date 040218
Caution & Safety
WARNING - TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have questions, contact
the manufacturer.
b) Before servicing or cleaning the unit, switch power off at the service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent warning device, such as a
tag, to the service panel.
WARNING: If unusual oscillating movement is observed, immediately stop using the ceiling fan
and contact the manufacturer, its service agent or suitably qualied persons.
WARNING: Make sure to power the fan off and lock it out using the IEC/CE approved disconnect
when doing any cleaning and or maintenance to the equipment.
PRIOR TO THE INSTALLATION, ENSURE:
• That the mounting of the suspension system shall be performed by the manufacturer, its
service agent or suitably qualied persons;
• That the fan is to be installed so that the blades are more than 10ft [3.05m] above the oor;
• The model or type reference of a luminaire that may be installed in a fan constructed for
this purpose.
DAMAGED EQUIPMENT
Do not operate or install any fans or fan accessories that appear to be damaged. Failure to follow
this instruction can result in death, serious injury, or equipment damage.
SERVICE:
If the fan does not operate properly using the procedures in this manual, BE CERTAIN TO
REMOVE ALL POWER TO THE UNIT and contact our technical department for further assistance.
Keep clear of moving parts at all times. All electrical troubleshooting and repair must be done by
a qualied technician and meet all applicable codes.
Ensure that the replacement of parts of the safety suspension system device shall be performed
by the manufacturer, its service agent or suitably qualied persons.
Key Safety System Components
MacroAir fans are engineered with key safety features to prevent pieces of the fan from falling in
the unlikely event of a catastrophic failure. Used together, these features provide comprehensive
protection of people, equipment and property. Follow the detailed instructions precisely when
installing fans, including the following:
• Install the safety cable on EVERY fan. The safety cable, if installed per MacroAir
specications, will prevent the fan from falling in the unlikely event that the mounting
system should fail. A MacroAir fan should never be run without a properly installed safety
cable, which is supplied with every fan along with all required hardware. You must install a
safety cable for the warranty to be in effect.
• Install guy wires on every fan, unless otherwise specied. Properly installing the guy wires
is required for proper stabilization during normal operation for some fan and mounting
types (Universal Mounts). In addition, guy wires keep the fan stable in case of earthquakes
or in “outdoor” installations where high wind conditions may occur.
To Next Page
Loading...
Need help?
General
