Status and error messages - The probe 36
Interference! (during ABR
test only)
• Ambient interference • Try to eliminate interference
sources. See section 5.5.1,
‘Placing electrodes for ABR
testing’ in the AccuScreen
PRO User Manual.
LCD test failed • LCD is defective. • Contact your service depart-
ment.
LED flashes, digit code is
shown
• Run-time error. • Make a note of the code and
contact your service depart-
ment.
No printer connected • Printer is not connected to
the device.
• Connect printer to the device.
• Printer is turned off. • Switch on printer.
No probe • Probe not connected to
device
• Connect probe to device
Out of labels • No labels in printer. • Refill labels.
Error message Cause Solution
To Next Page
Loading...