CONTROL ELEMENTS
Instrument panel
66 Operating manual MT 32 / 36
Four-wheel drive (switchable) <Fahrt schaltbar>
With the “switchable four-wheel-drive”, a “rigid” connection
between the front and rear axles is achieved, by engaging the
front wheel drive. You can use the switchable four-wheel drive
to increase the traction on slippery ground.
You can switch on the four-wheel drive even while you
are driving. However, the front axle only engages
shortly before the MT comes to a standstill.
Fig. 53: Four-wheel drive
1 “Four-wheel drive” switch
2 Control light
Switching on the four-wheel drive in continuous mode
and switching it off yourself
The four-wheel drive stays on until you switch it off yourself.
X To switch it on, press switch 1 up.
3 The switch latches into position.
3 The four-wheel drive is switched on in continuous mode;
control light 2 is lit.
X To switch it off, press switch 1 back to the centre position.
3 The control light 2 goes out.
3 The four-wheel drive is off.
The continuous mode of the four-wheel drive is for
example used in the event of snow and ice.
To Next Page
Loading...
