10. USING THE TURNTABLE
1. 2. 3. 4. 5.
Place the vinyl record onto the platter so that
the center hole aligns with the spindle.
Clean the vinyl record with a brush for vinyl
records with a gentle motion following the
grooves in the record. Finish with a diagonal
motion towards the edge of the record. Only
clean the vinyl records on the platter, when the
platter is resting on the platter feet.
Remove the cartridge’s protector, by pulling
straight forward. Applying a downward force
may cause the stylus to come off the body.
Only low volume is output if the stylus has
come off, or is about to come off, so refer to
“Replacing the stylus” on page 34 to reattach
the stylus correctly.
Turn the control button clockwise from OFF
mode (9 o’clock) , to 33 (33.3 rpm – 12 o’clock)
or 45 (45 rpm – 3 o’clock), depending on the
speed the record is supposed to be played at.
This turntable only plays 33.3 rpm and 45 rpm
records.
Lift the tonearm from the tonearm rest, and
move it toward the vinyl record.
Place the cartridge of above the track on the
vinyl record you wish to listen to. Make sure
you place the stylus above the vinyl record, to
not damage it.
ONLY PLACE, CLEAN, SWITCH
AND TURN THE VINYL RECORDS
WHEN THE LEVITATING PLATTER
IS RESTING ON PLATTER FEET.
WARNING
If using small 45rpm vinyl records with
a large center hole, place the 45rpm
adapter on the spindle, before placing
the record.
12
Make sure the cueing lever is in
downward position (page 21).
10.1. Playing a record
27
To Next Page
Loading...