12. REPLACING A CARTRIDGE
Make sure you are only using cartridges sug-
gested by MAG-LEV Audio with the turntable.
You can nd a list of recommended and
allowed cartridges at this
website www.maglevaudio.com.
Be aware that cartridges not on the list might
not work with the turntable and may damage
your record or parts of the apparatus.
Refer to the user manual for the cartridge that
you will be using if you are replacing the car-
tridge (Ortofon OM10) included with this prod-
uct with another, commercially sold cartridge.
After you replace the old cartridge with a new
one, you must readjust the overhang and the
tonearm’s balance and tracking force.
REPLACING THE STYLUS
Please check the instructions from the
manufacturer of the cartridge, to see how
to replace the stylus.
1. 2. 3. 4.
Remove the lead wires. Be careful not to
damage the lead wires.
Using a commercially sold, non-metallic
slotted screwdriver, remove the installation
screws, and then remove the cartridge from the
headshell.
Refer to the user manual for the new
cartridge for mounting instructions.
Using a commercially sold, non-metallic slot-
ted screwdriver, tighten the screws in both
places, and then adjust the overhang. After the
adjustments are complete, tighten the screws
securely.
The overhang is already set for the mount-
ed Ortofon OM10. If you wish to change
the cartridge or have bought the turntable
without one, please read the instructions
from the catridge manufacturer.
The position of the cartridge must be accu-
rately determined (adjusting the overhang)
when mounting a cartridge or headshell
other than the one provided.
Adjust the tonearm balance and tracking force.
Refer to “Tonearm balance and tracking force
(page 20) to perform the readjustments.”
1.a
1.b
35
To Next Page
Loading...