6. PREPARING THE SURFACE / SPACE 7. UNPACKING
Take out the RCA cables and remove the ties.Remove the top half of the Styrofoam box. Grip
on the sides with both hands and lift vertically
out of the cardboard box. Place it on a solid
and at surface.
50 cm
/ 20“
Place it at least 30 cm from the package.
1. 2. 3.
Read the entire user manual before unpacking
the apparatus.
Always follow instructions when unpacking the
apparatus.
Make sure you set up the surface you wish to
put the apparatus on in a level position and
make sure the surface is at before unpacking.
The product should always be placed
on a surface with enough area to t
the product feet fully on the surface.
Optimum recommendation (width x depth):
480 mm x 450 mm / 19“ x 17,7“.
READ THE
ENTIRE USER
MANUAL!
MAKE SURE TO USE
THE CORRECT
TOOLS TO
MAKE SURE THE
SURFACE IS LEVEL.
1. Make sure you set up the surface you
wish to put the apparatus on is level
and make sure the surface is at.
2. The product should always be placed
on a surface with enough area to t
the product feet fully on the surface.
3. Make sure the table, cabinet or sur-
face has no metal parts that interact
with magnets. Be certain to check
on, next to and under the surface to
make sure there are no metal parts in
the vicinity that would cause interfer-
ence with the turntable. (we suggest
wooden surfaces)
4. Any metal or magnetic parts should
be at least 50cm or 20“ away from the
turntable.
5. Make sure the speakers, preamps,
ampliers and other electronic equip-
ment is positioned at least 50cm or
20“ away from the turntable.
6. To avoid effects of vibrations and
acoustic pressure, do not mount the
product next to such items as speak-
ers.
7. The product may pick up radio static
if placed next to a radio. Therefore,
try to keep the product away from
radios.
8. If the product is near equipment (cell
phone, etc.) that emits strong radio
waves, noise may occur.
30 cm
/ 12“
11
To Next Page
Loading...