MAG-LEV audio ML1 - Page 9

4.
When the turntable is plugged into the
electric power grid for the rst time, the platter
feet will rise out of the turntable body into set
up position.
When the light in the control button stops
blinking, the turntable body set up is nished.
5. 6.
Lift the levitating platter vertically out of the
upper half of the Styrofoam box.
BE SURE TO LEAVE THE APPARATUS
PLUGGED IN FOR A MINIMUM OF 60
MINUTES BEFORE FIRST USE, FOR THE
APPARATUS TO WORK AS INTENDED.
Power adapter with power cord
AC input: AC100-240 V / 50-60 Hz / 2.0 A
DC output: 12V / 0.5 A
Operating temperature at normal playing
condition (room temp. 25°C) is
approximately 35°C.
2. step
Connect the power
adapter and power cord.
1. step
Plug the power cable into
the DC inlet.
3. step
Plug the power plug into
the outlet.
Connectable equipment
(Amplier, etc.)
To outlet
IT IS EXTREMELY IMPORTANT TO FOLLOW THE STEPS ON HOW TO
CONNECT THE TURNTABLE. IF THE STEPS ARE NOT FOLLOWED, IT
CAN CAUSE DAMAGE TO THE TURNTABLE.
17