Calibrating the Compass
The electronic compass requires that it is recalibrated every time you change the batteries.
Failure to calibrate the compass could result in errors of 20° or more to the displayed
head-ing. Calibration is very simple and won’t take more than a few minutes.
It is very important that there are no metallic objects near the eXplorist 300 during this
calibration.
1. Remove the eXplorist 300 from any cradle it may be in.
2. Press MENU.
3. Use the Arrow joystick to highlight Preferences.
4. Press ENTER.
5. Use the Arrow joystick to highlight Compass Calibrate.
6. Press ENTER.
7. Read the Attention message and press ENTER.
8. Lay the eXplorist on its back on a flat, horizontal surface and press ENTER.
Be sure to keep the eXplorist away from any metallic objects while performing
this step. Avoid placing it on a desk over a drawer that might be or contain
metallic objects.
9. Follow the displayed instructions and rotate the eXplorist in a clockwise manner,
keeping the displayed arrow pointing towards you.
10. If the calibration is successful, CALIBRATION COMPLETE is displayed.
11. Press ESC.
Electronic Compass
63
To Next Page
Loading...
Need help?
General
