9
Turning the eXplorist On
To turn the eXplorist on, press the POWER button on the top right
side. To prevent the eXplorist from being turned on accidentally,
draining the batteries, you need to press ENTER when the
Startup
screen is displayed. You have approximately 30 seconds between
pressing the POWER button and pressing the ENTER button,
otherwise the eXplorist will automatically turn itself off.
Turning the eXplorist Off
To turn the eXplorist off, press the POWER button on the top right
side.
There is a 5-second countdown after you press the POWER button. If
you change your mind and decide to leave the eXplorist on, just press
the ESC button. If you press the POWER button during this
countdown period, the eXplorist will immediately turn off.
Turning the Display Backlight On/Off
The display backlight has three levels of intensity: off, low and high. When the eXplorist is
first turned on, the display backlight is off. Press the LIGHT button on the top left side of
the eXplorist to turn the backlight on low. Pressing the LIGHT button a second time sets the
backlight to high. To turn off the backlight, press the LIGHT button again.
Backlight
intensity changes
each time you
press the
LIGHT
button.
REMEMBER: Using the display backlight causes severe drain on
the batteries.
Starting Up
To Next Page
Loading...
Need help?
General
