17
Working with Routes
The route function allows you to link a series of landmarks
and travel, point by point, to a final destination.
A
B
C
D
Leg 1
Leg 2
Leg 3
The route depicted here is a three-leg route. Leg 1 extends
from landmark A to landmark B, leg 2 from landmark B to
landmark C, and leg 3 from C to D. The GPS 310 gives you
information on the NAV screens that directs you to the
destination of each leg sequentially.
Creating a Route
A route can contain up to 10 legs using any of the landmarks
stored in memory. If there is a route already in memory you
must delete the existing route before you can create a new one.
Access the Route Menu by pressing
MENU
until ROUTE
appears at the top of the screen. The display should say
“PRESS ENT TO CREATE.”
NOTE: If the display says PRESS ENT TO VIEW there is
an existing route and you must delete the existing route before
creating a new one. (See Deleting a Route for details.)
Press
ENTER
.
To Next Page
Loading...
