NDI HX
Name: specify a name for current task to facilitate server management,
which will be displayed in server list.
■
Source Video
■
Group name
Specify the Group name which the source belongs to. It is case-
insensitive, and should be a combination of A to Z, a to z, 0 to 9 and
special characters like _-. Multiple groups are supported, which should
be comma-separated.
By default, it is public.
■
Source name
By default, it is #serial-no#, serial number.
■
UDP Unicast indicates that the encoder sends a UDP stream directly to the
receiver. It is used where lower latency matters. And multiple simultaneous
streams will work independently for multiple receivers.
■
UDP Multicast indicates that the encoder sends the UDP stream to a
multicast group. It is used for one-to-many broadcast for lower CPU
utilization. Parameters in a multicast configuration include:
■
Multicast IP ranges from 224.0.0.0 to 239.255.255.255.
■
Subnet Mask can be legitimate value ranging from 255.0.0.0 to
255.255.255.0.
■
Time To Live ranges from 1 to 255. The default value is 4.
■
Discovery Server: turn on the switch to auto-detect a source sender in
different network segment and ping the sender. And the Server IP should
be the IP address of the server running discovery server software. By default,
■
To Next Page
Loading...
