USING YOUR COOKTOP
STAINLESS FINISH COOKTOP
Due to certain atmospheric conditions To install grates: Models with lighter pilots:
and becauseof oxidationfromthe sur- 1. Placegrateoncooktop,locatingeach To lightsurfaceburners,turntheknobto
face burner pilot,the stainless top on ofthefourgratelegsontopofthefour the left (counter-clockwise)to the "Hi
your appliancemayshow signsof rust blackplasticgrommets. Lite" position.When the burner lights,
on the underneath side. This is espe- adjust knob to desired flame size.
cially true in areas of high humidity and
salt air areas. _ _ Models without surface burner pi-
To helpeliminatethiscondition,caution _ _ lots:
should be taken to make sure that the !_ _ Lightmatch.Turn control knobtothe left
underneath side of the main top is kept _=_._- _-_. : (counter-clockwise) to the "Hi Lite" pc-
dry.This isespeciatlyimportantinareas "_______.___.__ sit,onand apply lighted match ,mmedi-
of high humidity where moisture accu- _-_.__ _ _._ ately to the burner. Adjust knob to the
mulates. If you detect signs of rust. we _ desired flame size.
havefound it helpfulto spraythe under-
neath side with a coat of high-heat
tested rustolium or silicone paint. 2. Pressdown ateach corner to secure
burner grate to cooktop.
CAUTION; Removetop from appliance
and spray in a well vented area. SURFACE BURNERS
The surface burner control has no pre-
BURNER GRATES set position.The flame can be adjusted
Burner grates must be properly in- to any desired height between "OFF"
stalled. Do not operate burners without and "HI".
a pan on thegrate. The porcelain finish CAUTION
may chip without a pan to absorb the Do not turn control knob on and allow
heat. gas to escape before lighting match.
_4 m
To Next Page
Loading...
