Need help?Do you have a question about the Magicar M871A and is the answer not in the manual?
General| Type | Two-way car alarm system |
|---|---|
| Power Supply | 12V DC |
| Operating Frequency | 433.92 MHz |
| Features | Remote start, keyless entry, anti-hijack |
| Compatibility | Compatible with most 12V vehicles |
| Anti-Theft Protection | Yes |
| Shock Sensor | Adjustable sensitivity |
| Remote Control | LCD remote control with two-way communication |
Serial number for warranty, product for car security only.
MAGICAR M871A is a high-security safety device with a 2-way remote pager.
Describes the color LCD display and its function to inform car status.
Details and explains the meaning of icons shown on the remote control display.
Explains the function of each button and combination press on the remote.
Details arming, disarming, locking/unlocking, and engine blocking functions via Button I.
Activates/deactivates vibrating mode on the remote, indicated by an icon.
Enables entry into AUX mode for operating additional car equipment.
Triggers AUX 1 output after entering AUX mode by pressing Button II.
Triggers AUX 2 output after entering AUX mode by pressing Button III.
Releases the car trunk if equipped with an electric lock.
Activates the remote control's backlight for approximately 10 seconds.
Checks the car status, showing door, lock, and battery status on the remote.
Displays the actual inside vehicle temperature (°C/°F) or 'FAIL' if not connected.
Displays the car's battery voltage.
Displays the current voltage of the remote control's battery.
Allows checking parking or driving time, with display alternating between current and parking time.
Prevents accidental button presses by locking the remote buttons.
Activates panic mode, causing siren and lights to activate for a set duration.
Turns the siren sound on or off during arming/disarming operations.
Disables most alarm functions, useful for service or lending the car.
Disables shock and additional sensors during armed mode, useful for pets in car.
Locks car doors automatically after engine start and pressing the brake pedal.
Automatically arms the system after ignition is off and doors are closed.
Automatically arms/disarms based on remote proximity to the vehicle.
Allows the owner to be notified if someone is near the car by knocking.
Details how the alarm responds to strong or weak impacts detected by the shock sensor.
Explains alarm response to disturbance from additional sensors.
Describes alarm activation when doors, hood, or trunk are opened.
Blocks the engine from starting when the alarm is armed.
Warns the user if lights are left on after arming the vehicle.
Shows signal strength between the remote and the vehicle.
Indicates low battery and limits remote confirmation signals to save power.
Optional function where hazard lights flash to indicate an open door.
Optional function where hazard lights flash to indicate an open trunk.
Saves time information during power loss for easier setup.
Step-by-step guide to enter Valet mode using the ignition and key.
Procedure to enter Valet mode using a 2-digit PIN code.
Explains how to deactivate Valet mode using the remote control.
Procedure for programming new remote controls into the system's memory.
Instructions for changing the default PIN code for Valet mode access.
Guides on setting up a 4-digit security code for disarming the alarm.
Procedure to disarm the alarm using the 4-digit security code via RPS.
Allows setting present time, alarm clock, RPS, and temperature units via remote.
Explains shock sensor adjustment for different vehicles and mounting conditions.
Details how to increase the siren's volume by modifying a wire.
To Next Page
