Magicard 300 Series - Printer Error Codes: SD Card, Install, Feature Errors

ID Card Printer – User Manual
40
20
SD WRITE FAILURE
20:0
While performing a system software update, an
error occurred while trying to write temporary
update data to the SD card.
20:2
While attempting to apply an upgrade, the printer
was unable to create the upgrade directory on the
SD card. Either the SD card is missing, unformatted
or functioning incorrectly.
20:3
While attempting to install a custom Holokote
image, the printer was unable to create the
overcoat directory on the SD card. Either the SD
card is missing, unformatted or functioning
incorrectly.
20:4
While attempting to update the system image, the
printer was unable to create the system upgrade
directory on the SD card. Either the SD card is
missing, unformatted or functioning incorrectly.
20:5
While attempting to format the SD card at the start
of a soak routine, the formatting process failed.
21
INSTALL FAILURE
21:0
While performing a system software update, an
error was reported by the software update script.
22
NO DUPLEX
22:0
The printer received a double-sided print job but
does not have duplex printing enabled.
23
NO MAG HEAD
23:0
The printer received a print job which required mag
encoding but does not have mag encoding enabled.
This printer does not have a magnetic encoder
fitted and is unable to process this file type.
24
NO COLOUR FILM
24:0
The printer received a colour print job but does not
have colour film fitted.