Magicard 300 Series - Printer Error Codes: Overcoat and Motor Faults

ID Card Printer – User Manual
41
25
NO OVERCOAT
25:0
26
MOTOR FAULT
26:0
The print engine MCU reported a dye film motor
fault.
26:1
The print engine MCU reported a card feed motor
fault.
26:2
The print engine MCU reported a printhead cam
motor fault.
26:3
The print engine MCU reported a flip position motor
fault while moving the card. Note that this is the
flipper motor which drives the card, not the
rotation motor.
26:4
The print engine MCU reported a flip position motor
fault while rotating the flipper. Note that this is the
flipper motor which drives the card, not the
rotation motor.
26:5
The print engine MCU reported a flip rotation motor
fault. Note that this is the flipper motor which
rotates the flipper, not the one which drives the
card
26:6
The print engine MCU reported a main card drive
motor fault.
27
CLEAN REQUIRED
27:0
On start-up, the printer detected that it was
overdue for cleaning.