Please make sure the food processor bowl, lid , protective
cover and safety lock buckle are firmly locked to activate the
safety lock system or else the appliance won’t turn on !
Make sure the bowl, lid, protective cover and safety lock
buckle are NOT BROKEN, or else it is hard to activate the
safety lock system!
Ensure correct assembly, please pay attention to the lock and
unlock direction on the bowl / lid and motor base, please
follow the arrows and markings to lock them firmly.
NEVER try to install the bowl with handle on the left, it
cannot be installed! Please install the bowl with handle on the
right as the guiding markings on the base.
The bowl should be firmly locked to activate the safety locks,
a new appliance could be a little tight to lock the bowl to the
end, you may need a stronger push and make sure the handle
with a 90-degree angle (3 o'clock position) facing to the
right side, please try a clockwise click one more time if not
locked in place.
Make sure power plug is plugged in properly.
Check if the mains have tripped, or if there is a power outage.
To Next Page
Loading...
