Put the appliance on a flat smooth place , the sucker feet can
help to keep the balance of the appliance, make sure the
rubber feet are clean and dry.
Vibration is normal as some heavier loads (e.g.,grating
cheese/ making a dough) may require the motor work
harder.
Make sure that the max load capacity is not being exceeded.
Please put lesser food each time or else the appliance may
loose balance, process in batches to avoid over loading.
Please chop food into smaller pieces (such as cutting meat
into 2.5 cm pieces) and put them evenly into the bowl to
avoid shaking at start-up.
Please install the chopper blade and drive shaft together as
manual, the blades must be firmly installed. Find the UP side
and never install the chopper blade in the wrong direction,
incorrect installation may result in abnormal vibration.
Visible shake is normal while making a dough ( It will shake
more obviously if it is more than 400g flour ), please press
down upon the lid till the a dough is finished, only need
30-60 seconds to finish a nice dough, do not let the
appliance working too long each time. Process in batches to
avoid over loading.
Please make sure the chopper blade is properly install, please
refer to chopper blade chapter or installation chapter on the
manual.
DO NOT let the drive shaft working with 2 layers accessories,
such as a chopper blade on the bottom and a slicing
/grating blade on the top, it is NOT ALLOWED !
Please chop food into smaller pieces (such as cutting meat
into 2.5 cm pieces) before putting them evenly into the bowl.
Please do not chop ice or bone, it hurts the blade !
To Next Page
Loading...
