DRIVE SETUP
76
Example:
(With #150=On)
S2 S1 S0 Pre-set # Use
0 0 0 none Zero Speed select
0 0 1 1 Leveling Speed
0 1 1 3 1 Floor Run Speed
1 1 1 7 Multi-floor Run Speed
0 1 0 2 Inspection Speed (could also be speed 4, 5, or 6)
NOTE: Always set all other unused pre-set speeds to zero.
Table 11: Binary Input Control
Example:
(With #150 = Off, & #112 = On)
S4 S3 S2 S1 S0 Pre-set # Use
0 0 0 0 0 none Zero Speed select
0 0 0 0 1 1 Inspection speed w/ R-R 1 rates
0 0 0 1 0 2 Leveling Speed, w/ R-R 1
0 0 1 1 0 3 1 Floor Run Speed, w/ R-R 2
0 1 1 1 0 4 Multi-floor Run Speed, w/ R-R 3
1 1 1 1 0 5 Express zone speed (optional)
Table 12: Progressive Input Control
To Next Page
Loading...