inteleSmart2 Instruction Manual
June 2016
Page 34 of 49
CAN Configuration section
The right section of the Unit Info page allows the user to modify the CAN-bus network communication
settings.
CAN
This allows the user to modify the CAN Settings.
Source Address
This is the address that the inteleSmart2 will use as the source address when transmitting messages on
the CAN-bus network.
Baud Rate
This pull-down menu allows the user to modify the communication speed of the CAN-bus network. The
user selectable options are 50k, 125k, 250k and 500k.
7.4.2 Programming Page
See the RCP User’s Guide for complete details on programming the inteleSmart2 receiver.
To Next Page
Loading...
