2 - Connection Types
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 24 of 245 (D998200115-17)
Commands that use two-byte Command Numbers are called Extended Commands. Generally these are
commands that require a Data Length that is longer than the number of bytes available in a single report.
The host must call these commands using Command 0x49 - Send Extended Command Packet
(Extended Commands Only). Similarly, commands that send responses greater than the number of
bytes available in a single report require the host to use Command 0x4A - Get Extended Response
(Extended Commands Only) to retrieve Extended Responses. See the documentation for those two
commands for details about how Extended Commands and Extended Responses work.
To Next Page
