6 - Magnetic Stripe Card Data Sent from Device to Host (MSR Only | Keypad Entry Only)
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 41 of 245 (D998200115-17)
6.2 Track 1 Decode Status (HID | TLV | GATT | SLIP)
This one-byte value indicates the status of decoding Track 1. If bit 0 is OFF, no error occurred. If bit 0 is
ON, the device found non-noise data that was not decodable, and the device reports the track data length
is zero and does not provide valid track data to the host.
6.3 Track 2 Decode Status (HID | TLV | GATT | SLIP)
This one-byte value indicates the status of decoding Track 2. If bit 0 is OFF, no error occurred. If bit 0 is
ON, the device found non-noise data that was not decodable, and the device reports the track data length
is zero and does not provide valid track data to the host.
6.4 Track 3 Decode Status (HID | TLV | GATT | SLIP, 3-Track Only)
This one-byte value indicates the status of decoding Track 3. If bit 0 is OFF, no error occurred. If bit 0 is
ON, the device found non-noise data that was not decodable, and the device reports the track data length
is zero and does not provide valid track data to the host.
To Next Page
Loading...
