Magtek eDynamo - Bluetooth LE Command 0 X06 - Erase All Non-Volatile Memory

8 - Commands
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 85 of 245 (D998200115-17)
8.3.13.4 Bluetooth LE Command 0x06 - Erase All Non-Volatile Memory
This command erases the Bluetooth LE module’s non-volatile memory, which returns it to its un-
configured factory default state. This includes erasing all bonds (see Bluetooth LE Command 0x07 -
Erase All Bonds). The command requires the host software to include a pair of Secure Code values in
the request to make sure the host software does not accidentally invoke this command.
After calling this command, either the host must send Command 0x02 - Reset Device or a user must
power it off for at least 30 seconds, then power it on, before the changes will take effect. Because this
property affects Bluetooth LE communication, it is best to send it using the USB connection.
Table 8-28 - Request Data
Byte offset
Field name
Description
0
Secure code 1
Set to 0x55
1
Secure code 2
Set to 0xAA
Response Data: None
Example Request (Hex)
Command identifier
Request data length
Request data
46
05
01 00 06 55 AA
Example Response (Hex)
Result code
Response data length
Response data
00
03
01 01 00