Magtek eDynamo - Command 0 X45 - Get Battery Percentage; Only)

8 - Commands
eDynamo| Secure Card Reader Authenticator | Programmer’s Manual (COMMANDS)
Page 82 of 245 (D998200115-17)
8.3.12 Command 0x45 - Get Battery Percentage (PM3 Only | PM4 Only | PM5 Only | PM6
Only)
This command is used to get the percentage of useful battery charge remaining, in a range between 0x00
(0%) and 0x64 (100%).
Request Data: None
Table 8-20 - Response Data for Command 0x45 - Get Battery Percentage (PM3 Only | PM4 Only | PM5 Only |
PM6 Only)
Offset
Field Name
Description
0
Battery Percentage
Result codes:
0x00 = Success
Example Request (Hex)
Cmd Num
Data Len
Data
45
00
Example Response (Hex)
Result Code
Data Len
Data
00
01
62
(Battery at 98%, almost full charge)