BA490801-en
Pos: 77 /Techn ische Dokument ation/Alle Ger äte/Übersc hriften/ Überschrifte n 1.1.1/S/Über schrift 1.1.1 : Single-Betri eb @ 1 2\mod_1231750604943_75.docx @ 301400 @ 3 @ 1
Pos: 78 / Techn ische Dokument ation/ Hebetech nik/ - Arch iv -/ 00 Heb etechni k - Alle/Inhalte/Warnung!/Inhalt: Warnung - Einzelb etr ieb RG @ 2 0\mod_1268321800281_75.docx @ 824738 @ @ 1
When operating the lift in Single mode, make sure the vehicle is not tilted. Otherwise the vehicle
may fall off the lift!
Pos: 79 / Techn ische Dokument ation/ Papier korb/H ebetech nik/Inha lt: S ingle-Betr ieb (m it War nung) R GE @ 20\mod_1268321049708_75.docx @ 824703 @ @ 1
Select "Single mode" by pressing this
button on the desired column.
Activation of this operating mode is
indicated by the lit LED on the selector
button and the letter S on the seven-
segment display.
The columns not in Single mode are
temporarily inoperative. This is indicated by
the letter A flashing on the seven-segment
display.
Use these buttons to raise or lower the lift. or
Pos: 80 / Tec hnis che Dokum entation/ Hebetechni k/- Arch iv -/ 00 Heb etechni k - Alle/In halte/ Inf o!/In halt : Inf o - Vers chiedene Hub säulen RGE @ 12\mod_1231755449651_75.docx @ 301710 @ @ 1
The single mode can also be used for several columns simultaneously
Pos: 81 / Techn ische Dokument ation/ Hebetech nik/ - Arch iv -/ 00 Heb etechni k - Alle/In halte/ Inf o!/In halt : Inf o - Si ngle -Betr ieb RGE @ 12\ mod_1231756197190_75.docx @ 301735 @ @ 1
Height offsets between individual columns will be maintained after switch-over to automatic mode.
The offset can be removed either
– by equalizing the carriages in single mode or
– by lowering all carriages to bottom position in automatic mode.
• Lift switches off once first carriage reaches upward travel stop.
Pos: 82 /----- Form at-----/ MAN UE LLE R UM BR UCH Se iten umb ruc h @ 0\mod_1134403577687_0.docx @ 1277 @ @ 1
To Next Page
Loading...
