MAHA MCL - User Manual

Questions and Answers

B
barbaraperkinsAug 5, 2025
What to do if my MAHA MCL Lifting columns experience sluggish operation?
- D
  David GreerAug 5, 2025
  If your MAHA Lifting columns are operating sluggishly, release the button and try again. If the issue persists, contact service. Possible causes include prolonged standing under load or insufficient lubrication.
B
Brian BenjaminAug 9, 2025
What to do if a hardware error occurred in my MAHA MCL Lifting columns?
- J
  joseph21Aug 9, 2025
  If a hardware error occurs with your MAHA Lifting columns, interrupt the voltage supply for 5 seconds. If the error persists after this, contact service.
A
Angel OlsenAug 13, 2025
What to do if I see no LEDs are ON on my MAHA Lifting columns?
- K
  Kendra RichardsAug 14, 2025
  If no LEDs are ON on your MAHA Lifting columns, it indicates that the emergency-stop is actuated. Enable the emergency-stop button to resolve the issue.
M
Melissa MorganAug 18, 2025
What to do if my MAHA Lifting columns lift has contacted obstruction or floor?
- C
  Christopher JohnsonAug 18, 2025
  If your MAHA Lifting columns lift has contacted an obstruction or the floor, raise the lift until the yellow LED goes off.
R
rwalkerAug 22, 2025
What to do if I see other LEDs are ON on my MAHA Lifting columns?
- F
  Francis RichardsonAug 22, 2025
  If other LEDs are ON on your MAHA Lifting columns, it indicates radio interference. Wait until the radio interference has stopped. This may be caused by devices transmitting on the 433 MHz band, such as garage door openers or radio sets.
A
Amanda VillarrealAug 27, 2025
What to do if my MAHA MCL Lifting columns experienced Error occurred (Watchdog)?
- M
  Mark MillerAug 27, 2025
  If an error occurred (Watchdog) on your MAHA Lifting columns, turn off the main switch and turn it on again after approximately 5 seconds. If the error repeats, contact service.
M
Megan MillerAug 31, 2025
What to do if my MAHA Lifting columns lift is not yet referenced?
- J
  james21Aug 31, 2025
  If your MAHA Lifting columns lift is not yet referenced, when a new column with new control is being connected after final assembly, lower the lift with the emergency-down function.