MAHA MCL - Raising and Lowering Operations

To Next Page

To Previous Page

BA491201-en

Pos: 64 / Techn ische Dokument ation/ Alle Ger äte/Über schr iften/ Überschri ften 1.1/U/ Überschri ft 1. 1: Ums chalten auf Gr oup-M odus @ 6\ mod_1178523038671_75.docx @ 91263 @ 2 @ 1

3.6

Switching over to Group Mode

Pos: 65 / Techn ische Dokument ation/ Hebetech nik/ 49 Radgr eifer-H ebebü hne n/12 01 MC L/BA/I nha lt: 4912 Umsch alten auf Gro up-Mod us MC L/ RGB @ 14\mod_1240917882212_75.docx @ 368047 @ @ 1

1 Switch to Group mode using the operating

mode button on the desired columns.

 LED "Group" lights up permanently.

Pos: 66 / Techn ische Dokument ation/ Alle Ger äte/Über schr iften/ Überschri ften 1.1/U/ Überschri ft 1. 1: Ums chalten auf S ingle-M odus @ 6\ mod_1178526273265_75.docx @ 91290 @ 2 @ 1

3.7

Switching over to Single Mode

Pos: 67 / Techn ische Dokument ation/ Hebetech nik/ 49 Radgre ifer-Heb ebü hnen/ 1201 MCL/ BA/I nha lt: 49 12 Umsch alten auf S ingl e-Mod us MC L/ RGB @ 14\mod_1240919500168_75.docx @ 368074 @ @ 1

1 Switch to Single mode using the operating

mode button on the desired column.

 LED "Single" lights up permanently.

Pos: 68 / Techn ische Dokument ation/ Alle Ger äte/Über schr iften/ Überschri ften 1.1/H/ Überschr ift 1 .1: Hebe n und Se nken @ 6\mod_1178521944593_75.docx @ 91237 @ 2 @ 1

3.8

Raising and Lowering

Pos: 69 / Techn ische Dokument ation/ Hebetech nik/ 49 Radgr eifer-H ebebü hne n/12 01 MC L/BA/I nha lt: 4912 H ebe n und Senk en MC L/RG B/RG A @ 22\mod_1293006318971_75.docx @ 959702 @ @ 1

• Before operating the lift, check that the number of

columns appearing on the display corresponds to the

number of columns actually logged in.

• All columns belonging to the same unit must be set

to the same channel.

• If the unit is opened there may be interference

problems with other transmission channels.

• When operating the lift in Single or Group mode,

make sure the vehicle is not tilted. Otherwise the

vehicle may fall off the lift!

1 Press "Raise" or "Lower" button.

 Lift stops once button is released or end position is reached.