MAHA MCL - Greasing the Load Nut

To Next Page

To Previous Page

BA491201-en

Pos: 100 /Tech nische D okumen tation/A lle G eräte/ Überschr iften/Üb ers chrifte n 1.1.1/Ver sio niert/Über schr ift 1.1 .1: Tr agmutter schmier en @ 6\mod_1178611641328_75.docx @ 91467 @ 3 @ 1

4.4.2

Greasing the Load Nut

Pos: 1 01 /Te chnis che Dok umen tation/ All e Ger äte/I nha lte/I nfo!/I nha lt: Inf o - W artu ngs in terv all: 6 M onat e @ 10\mod_1218714013958_75.docx @ 238417 @ @ 1



Maintenance interval: 6 months

Pos: 102 /Te chnis che D okum ent ati on/H ebe tec hnik/ 49 Rad greifer-H ebeb ühne n/120 1 MC L/BA/I nha lt: 4 912 Tr agm utter s chm ieren MC L/RG B @ 6\mod_1178611777625_75.docx @ 91480 @ @ 1

1 Lower the carriage to bottom position.

2 Remove the cap plug from the lubricating window (arrow).

3 Grease the load nut through the lubricating nipple using a grease gun.

4 Run the lift through a full raising and lowering cycle to distribute the grease evenly on the lifting

screw.

5 Repeat the lubrication procedure twice or three times.

6 At completion of lubrication reinstall the cap plugs.