BA490801-en
Safety Instructions for Commissioning
Pos: 18 / Tec hnisch e Dokume ntat ion/Heb etechni k/COL UMNLIF T/4900 01 Rad greifer-H ebebü hnen A lle/Inhal te/In halt: Si cherhei tsvorsc hriften für d ie Inbetr iebna hme RG-H BZ @ 6\m od_1178094134921_75.docx @ 90757 @ @ 1
• Use the lift on a hard, level surface only.
• The standard lift version may not be installed and commissioned in the vicinity of explosives or
flammable liquids.
Pos: 19 / Techn ische Dokument ation/ Alle Ger äte/Über schr iften/ Überschri ften 1.1/S/Über schr ift 1. 1: Sicher heits vorschr iften f ür den Betrieb @ 6\m od_ 1174 482 26895 3_75 .docx @ 76826 @ 2 @ 1
Safety Instructions for Operation
Pos: 20 / Techn ische Dokument ation/ Hebetech nik/ COLUMN LIFT/4 90001 Rad grei fer-Heb ebühne n Alle/I nhalte/I nhalt: Sicher heitsvor schrif ten für d en Betrieb RG-HBZ @ 6\mod_1178094657921_75.docx @ 9077 0 @ @ 1
• Read the detailed operating manual.
• Lift operation by trained personnel over 18 years only.
• Do not exceed the rated load capacity per column as indicated on the lift nameplate.
• Ensure an unobstructed movement of lift and vehicle.
• After raising the vehicle briefly, stop and check the lift supports for secure contact with the
vehicle.
• Closely watch lift and vehicle during raising and lowering cycles.
• The working area which cannot be overviewed by the operator should be monitored by a
second person.
• When operating the lift in single or group mode, make sure the vehicle is not tilted.
• Do not allow anyone to stay in lift area during raising and lowering cycles.
• Do not allow anyone to climb on lift or inside raised vehicle.
• Keep lift and vehicle free of tools and parts.
• When using the lift outdoors, lower the vehicle and stop operation when the wind velocity
exceeds 6 m/s.
• Push the support forks completely under the wheels or lift points of the vehicle to be raised.
• Do not drive over or pinch electrical cables.
Pos: 21 / Techn ische Dokument ation/ Alle Ger äte/Über schr iften/ Überschri ften 1.1/S/Über schr ift 1. 1: Sicher heits vorschr iften f ür Servi cearbeit en @ 6\mod_1174482270640_75.docx @ 76850 @ 2 @ 1
Safety Instructions for Servicing
Pos: 22 / Tec hnische Dokume ntat ion/Hebet echni k/COL UMNLIF T/4900 01 Radgr eifer-H ebebü hnen All e/Inhal te/Inhal t: Sicher heitsv orsc hriften f ür Ser vicear beiten RG -HBZ @ 6\mod_ 11780 95227 937_ 75.do cx @ 907 93 @ @ 1
• Service work may be done by authorized service technicians only.
• Turn off and padlock the main switch before doing any repair, maintenance or setup work.
• Disconnect the mains plug before opening the control box.
• Work on the electrical equipment may be done by service technicians or certified electricians
only.
• Ensure that ecologically harmful substances are disposed of only in accordance with the
appropriate regulations.
• Do not use high pressure or steam jet cleaners. Use of caustic cleaning agents may damage
the lift.
• Do not replace or override the lift safety devices.
Pos: 23 /Techn ische Dokument ation/Alle Ger äte/Übersc hriften/ Überschrifte n 1.1/V/Übers chrift 1.1: Verh alten im Störfall @ 6\mod_1178097008375_75.docx @ 90829 @ 2 @ 1
What to Do in the Event of Defects or Malfunctions
Pos: 24 / Techn ische Dokument ation/ Hebetech nik/- Ar ch iv -/00 H ebet echnik - Al le/I nha lte/ Inh alt : Ver ha lten im St örfa ll H BZ @ 1 9\mod_1267177095494_75.docx @ 794570 @ @ 1
• In case of defects or malfunctions such as uncontrolled lift movement or deformation of the
superstructure, support or lower the lift immediately.
• Turn off the main switch and secure it against unauthorized usage. Contact service.
Pos: 25 / Techn ische Dokument ation/ Alle Ger äte/Über schr iften/ Überschri ften 1.1/V/ Übersc hrift 1.1 : Verh alten b ei Unfä llen @ 19\mod _ 1267177245337_75.docx @ 794600 @ 2 @ 1
What to Do in the Event of an Accident
To Next Page
Loading...
