► OPERATING THE HYDRAULICS
The hydraulics are powered with an engine driven hydraulic pump and controlled with a position
control lever mounted beside the driver.
► HYDRAULIC POSITION CONTROL LEVER
The Hydraulic Position Control Lever is located on the RHS of the
operator.
Implements can be raised and lowered with the hydraulic
position control lever and can be stopped at any position
Hydraulic Position
Control Lever
RISE
To raise the implement : Pull the lever backward.
To lower the implement : Push the lever forward.
by stopping the lever.
DOWN
► LOWERING SPEED CONTROL KNOB FOR THE 3 POINT HITCH
hi k b l h d d d f h d li ’ h i li k d i
After finishing the work, always lower the implement to the ground and switch off
the engine, set the parking brake to avoid injuries and accidents.
Warning
T
s
no
contro
s t
e
ownwar
spee
o
t
e Hy
rau
c
s t
ree po
nt
n
age an
s
ocate
e
ow
the seat.
To slow the downward speed, turn the knob clockwise.
To increase the downward speed, turn the knob counterclock-
wise.
To lock, turn the knob clockwise;
Do not over tighten the knob.
39
To Next Page
Loading...
Need help?
General