Repair Manual MAN-00190
THAR CRDe BS-IV MAY 2012/Rev 1
The repair methods given by the manufacturer in this document are based on the technical specifications at the time of release. The methods may be modified as a result of changes introduced by the
manufacturer in the production of the various component units and accessories from which the vehicles are manufactured. The reproduction, translation, transmission, in part or whole of the present
document, are prohibited without the prior written consent of Mahindra & Mahindra Ltd. The use of this document by any person other than the trained personnel, at the Authorized Service Centre of
Mahindra & Mahindra Ltd., will amount to unauthorized use and shall be liable for penalty/prosecution© 2012 Mahindra & Mahindra Ltd.
stroke.
Holding the clutch in depressed condition loosen
the bleeding screw on slave cylinder by ½ to ¾ turn
and allow all the air escape in to the container
bottle.
Repeat the exercise till no air bubbles appears in the bottle.
During this operation ensure fluid level in reservoir.
Tighten the bleed screw properly.
Remove bleeding tube and place the dust cap o
bleed screw.
Check the fluid level in container and need be top
up to the ‘max’ level.
To Next Page
Loading...
