17
Mahr GmbH • Millimar C1202
!
The instrument is most accurate after approx. 30 minutes of operation. Inductive mea-
suring probes should be mechanically set to the electrical zero point before the rst
measurement. To do this, use the setup mode that indicates the raw value or absolute
value of the probe.
– Select the relevant measuring probe
type using ▼ or ▲
=> See Technical Data in the operating
instructions for compatible measur-
ing probes.
– Conrm entry by pressing 4 key or
cancel with Ó key
– Exit submenu with Ó or exit the set-
tings menu by pressing the
key.
To Next Page
Loading...
