8
FAULT POSSIBLE CAUSE REMEDY
Irregular cut Worn or broken blades Sharpen or replace blades
Noisy machine
Loose parts Check all bolts are fully tightened.
Insufcient oil in gearbox. Check oil level and top up as necessary.
Incorrect PTO R.P.M. rate. Check PTO R.P.M. and adjust as necessary.
Excessive vibration
Loose parts. Check all bolts are fully tightened.
Incorrect PTO rate. Check PTO R.P.M. and adjust as necessary.
Broken or missing blade or blade bent
following impact
Check blades and replace if necessary.
Trouble Shooting
To Next Page
Loading...
