11
Quick Start Templates: Sequencing with 0-Coast
To sequence a 0-Coast with the 0-CTRL, start the Clock by pressing the Clock button, patch the Pitch CV
Output to the 1v/oct input of the 0-Coast, and patch the Dynamic Gate to the 0-Coast’s Contour Gate
Input. Make sure the Dynamics combo pot is turned up to 3:00 or higher, that the Strength attenuator is
turned fully clockwise, and that at least some of the Strength Channel knobs are turned up. For best results
set Contour Sustain to 3:00 or greater (to start). You must always patch at least two cables between the
0-CTRL and the device to be controlled.
To Next Page
Loading...
