7
There are no preset behaviors on the 0-CTRL. There are no "modes.” Instead you patch program the
sequence behaviors using the eight Step Gate outputs, along with the touch plates, and the control inputs:
Strength, Time, Clock, Dynamic Reset, Stop, and Direction.
The Interrupt Touchplate allows you to enable or disable the Step Touchplates’ ability to Interrupt the
sequence.
When Interrupt is ON you will be able to force the 0-CTRL to any step by touching the
corresponding touchplate. When Interrupt is OFF, you will be able to generate touch CV and touch
gates without interrupting the clocked sequence.
The Clock Input makes it easy to sync the 0-CTRL to another device. The Clock Output is complex:
it contains both internal and external clocks, and is affected by the Time parameter.
It is of course possible to use Internal and External clocks simultaneously, creating hybrid rhythms in the
0-Ctrl’s sequence, and ??? at the Clock Output.
Overview (cont.)
To Next Page
Loading...
