MAKERBOT METHOD MANUAL PAGE 21
AUTOMATED XYZ CALIBRATION
Each time you attach a Performance Extruder or a new build plate, you will need to run the Automated XYZ
Calibration routine. This process will make sure that the Performance Extruders are positioned properly with respect
to the build plate when you begin a print.
Before inserting a Performance Extruder into the printer, use the nozzle cleaning brush to clean the extruder
nozzle tip of any debris or material. This is critical for attempting to run Automated XYZ Calibration. IMPORTANT
NOTE: Please make sure the extruder nozzles are 100% clean and there is absolutely no filament residue left. Your
calibration will otherwise be inaccurate and your print performance will suer from it.
Follow the instructions on the screen and remove the build plate. The MakerBot Method will then check and
record the X and Y locations of the extruders. When the screen prompts you, insert the build plate to continue. The
MakerBot Method will now check and record the Z locations of the extruders.
Once this process has completed, you will be ready to start a print.
MAINTAINING THE BUILD PLATE
The surface of the MakerBot Method build plate, known as the Grip Surface, allows for better print adhesion and
print quality compared to other types of build surfaces. However, over time the grip surface can become cracked and
damaged. If these cracks or tears begin to aect print quality, it is time to replace the grip surface. Visit HTTPS://
SUPPORT.MAKERBOT.COM to learn how to replace the grip surface.
Go to HTTPS://STORE.MAKERBOT.COM/ to order more Grip Surfaces and build plates.
OTHER ISSUES
For help with issues not covered in this chapter, please go to HTTPS://SUPPORT.MAKERBOT.COM.
To Next Page
Loading...
