MakerBot Replicator 2 - Using MakerBot MakerWare Software

34
USING MAKERBOT MAKERWARE
1c. Open the installer and follow the
directions to install the soware.
NOTE: You can find a video of this tutorial at http://www.makerbot.com/support/replicator2/videos.
1a. Go to your computer and open a browser session.
1b. Enter the URL makerbot.com/makerware and download the correct MakerWare installer
for your operating system.
1
Download and Install MakerBot MakerWare
MakerBot MakerWare is soware that prepares 3D models for printing and turns them
into instructions for your MakerBot Replicator 2.
i
http://www.monomachines.com/
http://www.monomachines.com/