MakerBot Replicator 2X - Page 4

TheZaxisendstopistheonelocateddirectlybehindthethreadedZaxisrodbehindyoubuild
platform.

19.PlugtheYaxisendstopcableconnectorintotheYAxisendstop.

TheYaxisendstopistheonelocatedinthebackleftcornerofyourReplicator2X.Togetthe
cableconnectorthere,routeitbehindthethreeZaxisrodsandunderthemetalcableclipnext
totheendstop.

20.Addnewziptiestotheplasticclips.

TherearethreeziptieholderclipsinthetopofthetheReplicator2X’sframe.Toattachcables
toaziptieholderclip,dothefollowing:

Takeathinziptieandbendacentimeterortwooftheendintoasharp,fishhookshape.Poke
theendofthehookthroughtheholeintheziptieholder.Tightentheziptiearoundthecableor
cablesenoughthatitholdsthemstill,butnotsomuchthatitcouldharmthecables.

TheziptieholderclipattheupperrightsideshouldholdtheXaxissectionsofboththemotor
andendstopcables.TheziptieholderclipatthebacktowardstherightsideshouldholdtheY
andZaxissectionsoftheendstopcables.Theziptieholderclipatthebackbytheleftcorner
shouldholdonlytheYaxissectionoftheendstopcable.

Thispartreplacementisnowcomplete!ReturntherightsidepaneltotheReplicator2X,plugin
yourbot,andtryoutyournewendstopcable.

