8. Remove clips and tape 9. Install Smart Extruder+
1. Remove tape
2. Remove filament and accessory box 3. Remove tape from leveling knobs
5. Adjust feet for stability 6. Unlock lid
7. Remove lid
4. Place on a stable surface and remove
the protective film
Exercise caution when accessing the top compartment, and always keep it locked
when your MakerBot Replicator Z18 is in use. It contains hot surfaces and moving parts.
Caution: Two people are required to li the MakerBot Replicator Z18.
Do not li alone. To prevent injury, li with your legs, not your back.
NOTE: Hold on to your box and packaging materials
in case you need to transport your MakerBot
Replicator Z18 in the future.
To Next Page
Loading...
