To Next PageTo Next Page
Need help?Do you have a question about the Makita HP1030 and is the answer not in the manual?
General| Type | Hammer Drill |
|---|---|
| Chuck Capacity | 1.5 - 10 mm |
| Speed | 0 - 2, 800 rpm |
| Impact Rate | 0 - 44, 800 ipm |
| Drilling Capacity (Wood) | 20 mm |
| Power Source | Corded |
| Voltage | 220-240 V |
| Chuck Size | 10mm |
Guidelines for maintaining a clean, safe, and well-lit work area and proper tool storage.
Advice on correct tool operation, personal protection, maintenance, and safe practices.
Instructions on inserting and tightening drill bits using the chuck key into multiple holes.
Explanation of 'Drilling Only' mode for wood and steel, and setting the tool for rotation.
Guide to using hammer drilling for concrete, tile, or mortar with pilot hole advice.
Details on using the speed screw for continuous operation and the reversing switch.
Procedure for clearing clogged drill holes without excessive pressure.
How to use the depth rod for drilling holes of uniform depth.
Guidance on tool upkeep, carbon brush replacement, and bit sharpening.
List of accessories recommended for use with the Makita Hammer Drill.
Detailed itemized list of parts with corresponding numbers and descriptions.
Information regarding the warranty policy, coverage, and limitations.
